Wireless serial networking setup of Ntablet

Support

In order to save your time, you can find the services you need in the self-service.

If not, you can contact our customer service staff and we will serve you wholeheartedly.

there are 2 ways to config the networking for the wireless serial for the charging dock of Ntablet.

1) config it with WeChat app.
2) config it with AP network.

WeChat distribution network tutorial
Press the AP button first, then the AP LED would blinking.
go to WeChat public accont of Yea Create. And select “network setup” in the product center menu. Notice:Your phone must be connected to your WIFI first. When network setup is successful, the AP LED and STA LED of the will be on.Connect the SSID of the charging dock with your mobile phone or PC and enter the default password.built-in web login interface of wireless serial would be appeared and the default username and password is admin. login the built-in web, click the hardware menu for viewing the IP address of the STA. You can use that IP address to log in this hardware by other devices which in the same lan.

AP network setup tutorial
Power up the charging base, the AP LED would be on,Connect the SSID of the charging dock with your mobile phone or PC. The default wpa password is 12345678.Your browser would be redirect to a login page. Login into the built-in web page of the wireless serial, the default username and password is admin. click the hardware menu for connecting this hardware to your WIFI router or AP. Click “search SSID”, find out the SSID of your WIFI router, and enter the password of your WIFI router, the device would be reboot after submit. If your are in a DHCP network, you can check the STA IP of the device with the same way. You can use that IP address to log in this hardware by other devices which in the same lan.

Wireless serial of charging dock built-in web page sending and setting introduction
Login into the built-in web of the wireless serial with your browser in your PC , the default user name and password is ‘admin’, put the Ntablet into the charging dock,and click the “send message” menu. Then , you can operate or do some debug for the Ntablet. The “reboot” button is used for cold reset the Ntablet.

menus:
Setup

Restore factory default: It would clear all configurations for the wireless serial.

System configuration backup: backup configurations for the wireless serial.

System configuration restore: restore configurations form a backup file for the wireless serial .

Upgrade: download firmware form our official website if update available, and upload the firmware here.